Welcome to World Floor Expo!

Metroflor Matte Finish

This water-based coating is similar to the gloss finish and is designed for use on tile or plank where a matte finish is desired. Good for all vinyl installations. Spread rate is 400 sf/quart (one coat). New installations require two coats.

Much like gloss finish, but in a quite, satin finish. Matte finishes are excellent for those who like the appearance of Metroflor’s premium vinyl without the gloss, but need the added protection.

Preparation:


Thoroughly clean the floor. Remove all old finish using Metroflor Stripper. Pay particular attention to corners and baseboards to ensure that all old coatings have been removed. Scrub, rinse well with clear water and allow to dry.

Application:


Apply the finish in 2 light coats (on new floors) using a sponge mop, wax applicator or a damp, clean cloth. Put a small amount of finish in a shallow pan, dip mop and spread a thin, even coat. Do not leave any puddles. Allow to fully dry (tack free) for at least 45 minutes before applying second coat. Apply future coats as needed.

Note: Either Metroflor Gloss or Matte Finish is required in commercial settings. Metroflor Finishes are recommended in residential installations experiencing heavy use.

2 Item(s)

per page

Grid  List 

Set Descending Direction

2 Item(s)

per page

Grid  List 

Set Descending Direction